|
[Sponsors] |
[DesignModeler] change/increase model size box |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 23, 2013, 11:33 |
change/increase model size box
|
#1 | |
Member
Pjotr
Join Date: Mar 2012
Posts: 30
Rep Power: 14 |
Hi all)
Is it possible to change in Ansys DesignModeller the "model size box"? According to manual: Quote:
|
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Model size inconsistency between DesignModeler and Icem | Kristin_N | ANSYS Meshing & Geometry | 0 | April 12, 2012 08:55 |
[Commercial meshers] ST_Malloc: out of memory.malloc_storage: unable to malloc Velocity SA, | cfdproject | OpenFOAM Meshing & Mesh Conversion | 0 | April 14, 2009 15:45 |
Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 14:37 |
OpenFOAM 13 AMD quadcore parallel results | msrinath80 | OpenFOAM Running, Solving & CFD | 1 | November 10, 2007 23:23 |
size of first cell near wall for k-epselon model | mukkarum | FLUENT | 3 | May 11, 2004 04:10 |