|
[Sponsors] |
May 28, 2013, 11:06 |
Meshing periodic segment airfoil
|
#1 |
Member
Join Date: Feb 2010
Posts: 50
Rep Power: 16 |
Dear all,
I am trying to model three airfoils rotating. Similar threads have been posted. There also exists the great youtube tutorial. During that tutorial a mesh is shown that I'd like to create but due to my lack of experience I need some help. I added a picture of the mesh I'd like to have. How can I tell ICEM not to lead all edges to the center but to get parallel edges to the periodic boundary? Is there any tutorial on that? Any help is highly appreciated. Kind regards Philipp |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Meshing an airfoil (3D - OF 2.2.0) | A.Wendy | OpenFOAM Meshing & Mesh Conversion | 7 | October 12, 2013 13:07 |
[GAMBIT] meshing trailing airfoil | carp | ANSYS Meshing & Geometry | 4 | March 20, 2013 01:12 |
Airfoil Meshing | PLP3A_ENSIAME | STAR-CCM+ | 14 | October 10, 2012 18:29 |
[GAMBIT] Meshing with periodic BC | Daggemann | ANSYS Meshing & Geometry | 1 | April 7, 2009 07:16 |
Meshing An airfoil with a simple plain flap | S. Kalam | FLUENT | 7 | January 30, 2005 20:22 |