|
[Sponsors] |
January 21, 2014, 01:27 |
|
#21 |
New Member
mistigh
Join Date: Dec 2013
Posts: 3
Rep Power: 12 |
yes i have just figured it out after i posted it.I'm gonna try to mesh with filled holes now.Thanks Ali.
|
|
January 21, 2014, 07:33 |
|
#22 |
Senior Member
Javi
Join Date: Jan 2013
Posts: 276
Rep Power: 16 |
Maybe this can help you. This is Diamondx approach. I just try to repeat it. Here the result.
Multiple Pipe In Cylinder Blocking Here files: https://www.dropbox.com/s/0blxqh8z2p...20Cylinder.rar |
|
January 21, 2014, 15:24 |
|
#24 | |
New Member
Peyman
Join Date: Jul 2013
Location: Iran
Posts: 29
Rep Power: 12 |
Quote:
in your uploaded picture, you did not block the nozzle of exchanger. for blocking you should be split nozzle block http://8pic.ir/images/95435552099944766571.jpg so, after this step you can split block for the tubes. for delete block go.... blocking menu\delete block |
||
January 28, 2014, 10:37 |
|
#25 |
New Member
mistigh
Join Date: Dec 2013
Posts: 3
Rep Power: 12 |
Hey guys,
I have been trying to mesh this geometry with nozzle nowadays.I know it should not be that hard yet it is hard to figure it out what is going on as a begineer tbh.So i have done this blocking (below) many times and i only got one successful mesh at all.So here question is,is there any further ways to improve this mesh better,(i alrdy tried smooth mesh)?All suggestions would be appericiated. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
OpenFOAM static build on Cray XT5 | asaijo | OpenFOAM Installation | 9 | April 6, 2011 12:21 |
Turbulent flow in a cylinder pipe | SeRGeiSarov | Main CFD Forum | 0 | March 25, 2010 13:20 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |