|
[Sponsors] |
[ICEM] Problems to create a surface in ICEMCFD |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 7, 2013, 06:00 |
Problems to create a surface in ICEMCFD
|
#1 |
Member
Domenico
Join Date: Sep 2009
Location: Cranfield
Posts: 48
Rep Power: 16 |
Dear All, I am a beginner in using ICEMCFD and by considering four different edges. These were, in turn, obtained by merging different segments. After creating the surface, this does not look so regular as shown in the attached file. Does anyone have an idea about what happened? Many thanks in advance
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
Help ! Create surface for sliding mesh. | YH Tan | FLUENT | 0 | October 5, 2008 04:21 |
Surface creation problems with GAMBIT ! | enemi09 | FLUENT | 2 | February 26, 2005 10:52 |
create new surface | subhash | Siemens | 2 | July 30, 2002 03:53 |