|
[Sponsors] |
[ICEM] ICEM: Number of nodes in Curve mesh (inflation) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 24, 2014, 15:12 |
ICEM: Number of nodes in Curve mesh (inflation)
|
#1 |
New Member
LOTFI OULD ROUIS
Join Date: Jan 2014
Location: Canada
Posts: 23
Rep Power: 12 |
Hi People ,
I wanna realize an inflation around my blade profile in ICEM so that the turbulence model used in Fluent would match with the y+ (figure.1). When reading the ICEM manual it tells that the number of node selected in curve mesh parameters defines the number of nodes in the selected curve or edge to inflate. So the higher is the number of nodes the closer is the spacing element of the inflation. But this doesn't happen in my case (see figure.2 wich is a zoom of figure.1). In figure.2 we can see that in fact, ICEM added correctly the number of nodes I asked him but he doesn't relate these nodes to the mesh. How can I deal with that issue to get smaller space? Thanks a lot in advance, Lotfi |
|
February 26, 2014, 17:07 |
|
#2 |
New Member
LOTFI OULD ROUIS
Join Date: Jan 2014
Location: Canada
Posts: 23
Rep Power: 12 |
sorry I forgot to join the pictures :s
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
[ICEM] ICEM ignores curve mesh number | syavash | ANSYS Meshing & Geometry | 0 | August 8, 2013 20:04 |
Inner geometry gets lost exporting mesh from ICEM CFD to CFX-Pre | powpow | CFX | 3 | December 20, 2012 10:14 |
varying curve mesh spacing at icem surface-mesh? | mirko_r | ANSYS Meshing & Geometry | 6 | January 14, 2010 14:23 |
meshing F1 front wing | Steve | FLUENT | 0 | April 17, 2003 13:37 |