|
[Sponsors] |
[ICEM] how to connect blocks for the pre-mesh params |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
|
November 13, 2014, 05:27 |
how to connect blocks for the pre-mesh params
|
#1 |
New Member
matteo
Join Date: Nov 2014
Posts: 1
Rep Power: 0 |
Hello everyone,
I have a mesh of a rod bundle and a spacer for the periodic conditions with hundred blocks, that IŽll run in fluent. I would like to know if there are some possibilities to associate more edges of different blocks to get the mesh more fine in the right place like near the walls. The problem of this mesh is that I have inner walls and the blocks witch are referred to them are difficult to select. This is the dropbox link: https://www.dropbox.com/sh/mduvinx1x...uGZeVdSna?dl=0 Thank you for your help. IŽll appreciate all suggestions. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
[ICEM] Fine mesh of Local block methods. | Sheyko | ANSYS Meshing & Geometry | 0 | January 29, 2014 10:35 |
[Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |