[ICEM] how to connect blocks for the pre-mesh params -- CFD Online Discussion Forums

November 13, 2014, 05:27	how to connect blocks for the pre-mesh params	#1
cavalloteo New Member matteo Join Date: Nov 2014 Posts: 1 Rep Power: 0	Hello everyone, I have a mesh of a rod bundle and a spacer for the periodic conditions with hundred blocks, that I´ll run in fluent. I would like to know if there are some possibilities to associate more edges of different blocks to get the mesh more fine in the right place like near the walls. The problem of this mesh is that I have inner walls and the blocks witch are referred to them are difficult to select. This is the dropbox link: https://www.dropbox.com/sh/mduvinx1x...uGZeVdSna?dl=0 Thank you for your help. I´ll appreciate all suggestions.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
[ICEM] Fine mesh of Local block methods.	Sheyko	ANSYS Meshing & Geometry	0	January 29, 2014 10:35
[Gmsh] 2D Mesh Generation Tutorial for GMSH	aeroslacker	OpenFOAM Meshing & Mesh Conversion	12	January 19, 2012 03:52
[ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM	kawamatt2	ANSYS Meshing & Geometry	17	December 20, 2011 11:45
Convergence moving mesh	lr103476	OpenFOAM Running, Solving & CFD	30	November 19, 2007 14:09

All times are GMT -4. The time now is 10:22.