 |
 |
 |
|
|
|
[Sponsors] | ||||
December 21, 2014, 12:00
|
Problem with contacts
|
#1 |
|
New Member
fille alog
Join Date: Dec 2014
Posts: 1
Rep Power: 0  |
http://oi58.tinypic.com/2ezmgra.jpg
Take a look at the picture above. It is a hexagonal bolt inside a hexagonal sleeve . ♦ It is 8 mm between two flat parallel planes on the bolt. ♦ The gap between the bolt and the sleeve is 0.35 mm . ♦ The sleeve is fixed and there is a torque on the bolt to 20 Nm 1. Why is the maximum deformation over 4 kilometers? Where can I have done wrong? 2. Why is it tension in the bolt before it touches the sleeve?: http://oi61.tinypic.com/34skyfs.jpg 3. Must the sleeve and the bolt be in contact with each other in the assembly, before i import them in to ANSYS? |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
| Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
| Is this problem well posed? | Thomas P. Abraham | Main CFD Forum | 5 | September 8, 1999 14:52 |
Linear Mode
