 |
 |
 |
|
|
|
[Sponsors] | ||||
April 16, 2015, 06:04
|
Periodic Tet Mesh
|
#1 |
|
New Member
Ralf Becker
Join Date: Feb 2011
Posts: 7
Rep Power: 15  |
I would like to mesh a rather simple geometry with a tetra mesh and two translation periodic boundaries. I have setup the periodicty with "GLOBAL MESH SETUP -> PERIODICITY". With the OCTREE Mesher it works like expected, while any other mesher (Advancing Front, Delaunay, TGrid) does not generate a periodic mesh. Checking the periodicity with "RIGHT BUTTON MESH -> Periodicty" I get the message "No periodicty defined".
Which steps are necessary to generate a periodic mesh with these meshing algorithms? Thank you in advance Ralf |
|
|
|
|
| Tags |
| icem, periodicity, tetra |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Low quality Tet prism mesh | saisanthoshm88 | ANSYS Meshing & Geometry | 17 | September 28, 2016 16:50 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| Contrast of hex mesh , tet mesh and polyhetral mesh | Kiffer | Main CFD Forum | 1 | December 4, 2012 08:51 |
| [ICEM] hybrid mesh/Aligning tet with hex mesh | shridharsn | ANSYS Meshing & Geometry | 0 | October 17, 2012 11:29 |
| Convergence moving mesh | lr103476 | OpenFOAM Running, Solving & CFD | 30 | November 19, 2007 14:09 |
1Likes
Threaded Mode
