|July 2, 2015, 21:11||
Generate Mesh on Internal walls
Vinícius da Costa Ávila
Join Date: Jul 2015
Location: Porto Alegre, Brazil
Posts: 61Rep Power: 3
Could anyone give me some advice here?
I have introduced internal parts in my geometry and I have created new parts to name them. However, when I visualize the pre-mesh and even after I export the mesh, these internal parts just vanish.
The external parts: walls, inlet and outlet are ok, but the internal ones (membrane, cilindres and baffle) weren't export with the mesh.
I have attached 3 prints,
screen1: my geometry (walls in green, inlet and outlet in red, baffle in pink and membrane and cilindres in blue)
screen2: the pre-mesh, where we can see that the mesh were generated on the inlet and walls.
screen3: unchecking the walls (with the pre-mesh checked) we can see no mesh on the internal parts, just on the inlet and outlet (in red).
Anyone has any idea what I have missed that the exported mesh doesnt carry the internal parts?
|blocking, internal baffle, internal parts, internal wall, mesh|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Star CCM Overset Mesh Error (Rotating Turbine)||thezack||CD-adapco||7||October 12, 2016 11:14|
|[ICEM] Defining Interfaces and Splitting Internal Walls ICEM-FLUENT||pmtgt||ANSYS Meshing & Geometry||6||April 12, 2014 18:22|
|[ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM?||jash||ANSYS Meshing & Geometry||19||July 23, 2013 18:48|
|[ICEM] Generate multiply bodies and then mesh them one by one||hz283||ANSYS Meshing & Geometry||1||March 3, 2013 16:27|
|fluent add additional zones for the mesh file||SSL||FLUENT||2||January 26, 2008 12:55|