|
[Sponsors] |
July 30, 2015, 20:56 |
sequential node numbering in meshes
|
#1 |
New Member
Mirunalini
Join Date: Sep 2010
Posts: 2
Rep Power: 0 |
Hello,
Some of the meshes generated by ICEM do not have sequential node numbering. For example, in one of my nastran files (see attached), the node numbers are continuous upto 11 and then jump to 15. Is there a way to constrain the node numbers to be continuous while meshing in ICEM? https://www.dropbox.com/s/97rgvhvgo0...oud25.nas?dl=0 Thanks Mirunalini |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Error in mesh writing | helios | ANSYS Meshing & Geometry | 21 | August 19, 2021 14:18 |
Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 15:03 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
999999 (../../src/mpsystem.c@1123):mpt_read: failed:errno = 11 | UDS_rambler | FLUENT | 2 | November 22, 2011 09:46 |
Node numbering at interface in MeTiS. | mehul | FLUENT | 0 | December 19, 2006 10:22 |