 |
 |
 |
|
|
|
[Sponsors] | ||||
August 10, 2015, 07:31
|
Extrude 2D mesh
|
#1 |
|
Member
Jason
Join Date: May 2013
Location: South Africa
Posts: 32
Rep Power: 12  |
I have a 2D mesh that I need to extrude to a 3D mesh (apply thickness and inflation).
I have tried meshing a 3D model of my geometry using multizone/sweep but I cannot achieve the fully quad mesh that I desire. Finally I've tried setting my 2D mesh to 3D and applying a thickness to the geometry which gets me closer to what I want (a mesh with thickness). However, is there a way to apply an inflation/discretisation to this thickness? |
|
|
|
|
 |
| Tags |
| 2d mesh, airfoil mesh, inflation |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| [ICEM] Extrude mesh | luissanchez | ANSYS Meshing & Geometry | 2 | June 25, 2013 08:22 |
| [ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 04:24 |
| [ICEM] issue occur after extrude 2D airfoil mesh and convergence problem in CFX | shiyun | ANSYS Meshing & Geometry | 4 | May 9, 2012 19:55 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Linear Mode
