|
[Sponsors] |
August 23, 2015, 08:38 |
Parts fully invisble
|
#1 |
New Member
Gill
Join Date: Aug 2015
Posts: 1
Rep Power: 0 |
I am using ansys 16.0 . No no matter which files i use stp igs geometery is fully invisible
http://s16.postimg.org/4fqbabg39/Screenshot_64.png http://s16.postimg.org/4v1l3c20l/Screenshot_65.png When i move cursor over geometery it shows outline of parts but geometery is fully invisible tired of this . |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
UDF for fully developed turbulent flow at inlet | soroushsaberi | FLUENT | 0 | May 28, 2014 17:00 |
[ICEM] Generating mesh for modified parts in ICEM without changing mesh of other parts | a.habibi | ANSYS Meshing & Geometry | 5 | October 4, 2012 05:10 |
Fully developed flow in Star-cd | SMM | STAR-CD | 3 | September 9, 2011 15:54 |
How to handle suction and pressure side of an airfoil as two different parts? | TKE | ANSYS Meshing & Geometry | 0 | March 4, 2011 07:48 |
Creating 100 derived parts / Splitting derived parts for mass flux calculation | xamo | STAR-CCM+ | 8 | September 29, 2009 05:35 |