[Onurozcan]

Hi,

When I give a number of boundary layer thickness in inflation mesh,that is,first layer thickness,analysis take a long time.Instead If I would try to do that in total thickness, that will be opposite

So, total thickness is stand for to boundary layer thickness x growth rate based on iteration ,that is, depends on number of boundary layer .

Like below

Boundary layer thickness 0.01 Growth rate 1.2

First boundary layer thickness : 0.01
Second one : 0.01x1.2
Third one : 0.01x1.2x1.2
...last one (that is number of layer we define)

is it correct thought or not? If this is ok, I am going to do that.That's why solver time will be enough