[Onurozcan]

Hi,

This project is consist of tubes(flow through air) and waste air ( outer region).Accordingly y+ and boundry layer thickness are to be used.(shown below links)

The problem I have run across is in Ansys mesh.

Surface below body(actually the surface is just a part of multi-part) that have both tubes and waste gas flow domain contacts top of plenum(that is the surface).I would like to have same mesh in two section.ButI couldn't inflate on top plenum surface to have same mesh.

named selections in below the body and top of plenum (surface,both contact and interface) are instersected.But top of plenum mesh is not enough.

Could anyone know that is it possible to match same mesh? or is there any way out this problem?

http://imageshack.com/a/img905/4577/OEm87C.png

http://imageshack.com/a/img911/4632/oyWh5b.png

http://imageshack.com/a/img910/8733/pvkGxF.png

Kind Regards