|
[Sponsors] |
December 17, 2015, 05:45 |
Defining interface for 2d geoemrty
|
#1 |
Member
Dhayananth
Join Date: Jun 2014
Posts: 37
Rep Power: 11 |
My geometry is 2d and is shown in figure. It has two fluid zones and the red lines are the boundary separating fluid zones.
I meshed the complete geomerty in ICEM CFD and exported the mesh to fluent. I don't know how to define interface for red lines. I saw one thread, in that they mentioned split internal wall command to get two surfaces. In my case if press the command, its showing "no internal walls". Can any one give some suggestions to overcome the above problem. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Radiation in semi-transparent media with surface-to-surface model? | mpeppels | CFX | 11 | August 22, 2019 07:30 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |
Error finding variable "THERMX" | sunilpatil | CFX | 8 | April 26, 2013 07:00 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 04:05 |