|
[Sponsors] |
December 28, 2015, 23:34 |
invalid command name "13"
|
#1 |
Member
Nikesh Bhattarai
Join Date: Nov 2011
Location: Sacheon, South Korea
Posts: 82
Rep Power: 13 |
Hello ICEM users,
I get this error message at the last stage of my grid generation process in ICEM while setting up the solver. It saves the project but doesn't generate my .msh file. It only gives .uns file. I was doing a simple 2D airfoil mesh. invalid command name "13" I've been trying hard and googling as well but I can't seem to find what the problem is. Hoping someone here knows whats wrong. I'd appreciate it a lot. Thanks! Nikesh |
|
December 29, 2015, 04:42 |
|
#2 |
Member
Nikesh Bhattarai
Join Date: Nov 2011
Location: Sacheon, South Korea
Posts: 82
Rep Power: 13 |
Finally figured it out.....
For anyone who's stumbled upon the same problem.... The problem lies in the naming of the working folder or any of its parent folder. Make a clean folder with only letters and numeric in the desktop and start the project in that folder, it should work out fine. The .msh file so generated can then be copied to other folders and simulations performed. It should work just fine. Good luck! |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
parallel simulations - error message: "OPT_ITERATIONS: invalid option name" | v8areu | SU2 | 5 | July 23, 2015 02:57 |
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh | gschaider | OpenFOAM Community Contributions | 300 | October 29, 2014 18:00 |
Problems building Paraview 3.12 on Gentoo Linux | pajot | OpenFOAM Installation | 11 | April 11, 2013 08:09 |
OpenFOAM install on Ubuntu Natty 11.04 | bkubicek | OpenFOAM | 13 | May 26, 2011 05:48 |
Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 14:37 |