|
[Sponsors] |
[ICEM] Funny Problem Meshing Cylinder with ICEM |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 4, 2016, 14:10 |
Funny Problem Meshing Cylinder with ICEM
|
#1 |
New Member
Atashmard
Join Date: Jul 2010
Posts: 2
Rep Power: 0 |
Hello Everyone
It's so funny and still confusing. I was trying to mesh combination of pipes in ICEM. The funny thing is ICEM can not cover the corners of circle section in just this specific file. I've checked everything (assoc. edge to curves and etc) million times. The pictures has been attached. When I delete everything (Geo, blocks) and try a simple cylinder, it goes fine. Unfortunately I have spent a long time creating the geometry and do not want to start it over. Have you ever experienced a same thing? PS. I have tried o-grid and it does not make a difference. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Meshing inclined cylinder with PBC tetra mesh ICEM | shashi_soman | ANSYS Meshing & Geometry | 0 | September 26, 2015 18:27 |
[ICEM] ICEM Meshing Beginner facing problem importing file. | rrahman | ANSYS Meshing & Geometry | 0 | September 2, 2015 14:18 |
[ICEM] script for cylinder hexa meshing in ICEM | Far | ANSYS Meshing & Geometry | 0 | May 25, 2012 07:55 |
[ICEM] Simple meshing problem in ICEM | fkh | ANSYS Meshing & Geometry | 6 | February 14, 2012 13:01 |
[ICEM] (ICEM CFD) meshing over a cylinder | vmlxb6 | ANSYS Meshing & Geometry | 6 | August 11, 2010 14:37 |