|
[Sponsors] |
[ANSYS Meshing] Howto sweep non-sweepable Bodies? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
January 21, 2016, 06:01 |
Howto sweep non-sweepable Bodies?
|
#1 |
New Member
Join Date: Jan 2016
Posts: 2
Rep Power: 0 |
Hi Community,
my test model has a cylinder inside a cube. A third body covers the other two. (i attached geometry file). Is there a way to mesh the the thin cover with the same mesh as the cylinder and cube are meshed? Sweepable bodies cant be used on the cover body ... is there way to sweep the cover body with one divison and the same base mesh the cylinder and cube have? Hopefully somebody reads this and has a solution. geometry.jpg mesh.jpgetry file) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Non Sweepable bodies | b.shuvayan | ANSYS Meshing & Geometry | 22 | February 1, 2018 06:28 |
[ANSYS Meshing] Sweep mesh results in extreme aspect ratio | Highflower | ANSYS Meshing & Geometry | 4 | January 12, 2016 16:40 |
[DesignModeler] [ANSYS Geometry] Error: Operation would result in non-manifold bodies | -roberto | ANSYS Meshing & Geometry | 0 | April 10, 2015 06:33 |
[ANSYS Meshing] Inlet Pump - Creation of sweepable bodies | DarkRudy | ANSYS Meshing & Geometry | 5 | January 28, 2013 07:58 |
[ANSYS Meshing] sweepable bodies & meshing | sandy_1982 | ANSYS Meshing & Geometry | 6 | November 1, 2012 08:04 |