Help ICEM cfd

haze_ryder · February 13, 2016, 07:31

Dear all,
I need help.
When I try to make a surface from curves in ICEM cfd it shows surface not visible error.
What can I do to solve this.
Thanks in advance

rajnarayang · February 14, 2016, 20:55

Quote:

Originally Posted by haze_ryder

Dear all,
I need help.
When I try to make a surface from curves in ICEM cfd it shows surface not visible error.
What can I do to solve this.
Thanks in advance

Could you please post the snapshot of the error?

haze_ryder · February 14, 2016, 22:53

The geometry was imported (iges)

bluebase · February 15, 2016, 07:15

I guess, this is not an error. Do the following: in the model tree, activate surfaces. The message just tells you the imported geometry is not visible due to your visibility settings on geometry (points,curve,surfaces).

haze_ryder · February 15, 2016, 08:25

Thanks a lot blue base...
I don't know if this is the right place to ask this. I always get an error in fluent 15 after it had completed some iterations. It states the f1 process could not be started an the program doesn't respond. It won't even save

February 13, 2016, 07:31	Help ICEM cfd	#1
haze_ryder New Member haze Join Date: Feb 2016 Posts: 6 Rep Power: 9	Dear all, I need help. When I try to make a surface from curves in ICEM cfd it shows surface not visible error. What can I do to solve this. Thanks in advance

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Icem CFD on Linux	mechanicaldesign	ANSYS Meshing & Geometry	7	March 11, 2021 19:44
Need help icem cfd	kakhtar	ANSYS Meshing & Geometry	25	January 31, 2017 01:09
Transport mesh from ICEM CFD, to Fluent, to Sysnoise	Wieland	FLUENT	2	April 15, 2012 06:28
Importing Solidworks part into ICEM CFD	MetalSupremacist	FLUENT	0	October 8, 2010 17:46
Which is better to develop in-house CFD code or to buy a available CFD package.	Tareq Al-shaalan	Main CFD Forum	10	June 12, 1999 23:27

February 15, 2016, 07:15		#4
bluebase Senior Member Sebastian Engel Join Date: Jun 2011 Location: Germany Posts: 566 Rep Power: 19	I guess, this is not an error. Do the following: in the model tree, activate surfaces. The message just tells you the imported geometry is not visible due to your visibility settings on geometry (points,curve,surfaces).

February 15, 2016, 08:25		#5
haze_ryder New Member haze Join Date: Feb 2016 Posts: 6 Rep Power: 9	Thanks a lot blue base... I don't know if this is the right place to ask this. I always get an error in fluent 15 after it had completed some iterations. It states the f1 process could not be started an the program doesn't respond. It won't even save