 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] Error in sending coordinate file to ansys designmodeler |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 24, 2019, 13:58
|
Error in sending coordinate file to ansys designmodeler
|
#1 |
|
New Member
Pedro Garcez Silva
Join Date: Apr 2019
Posts: 1
Rep Power: 0  |
Hello,
I am trying to make a NACA 0012 geometry on designmodeler, from the text file. However, I keep gettin the error message "error reading Coordinates file". I have followed the guidelines from the user guide, and the text seems fine, and I anexed it along with the message. I would be very grateful if someone helps me with this. Thanks in advance! |
|
|
|
|
|
| Tags |
| naca0012 designmodeler |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [swak4Foam] Installation Problem with OF 6 version | Aurel | OpenFOAM Community Contributions | 14 | November 18, 2020 16:18 |
| OpenFoam "Permission denied" and "command not found" problems. | iyidaniel@yahoo.co.uk | OpenFOAM Running, Solving & CFD | 11 | January 2, 2018 06:47 |
| polynomial BC | srv537 | OpenFOAM Pre-Processing | 4 | December 3, 2016 09:07 |
| [OpenFOAM.org] Compile OF 2.3 on Mac OS X .... the patch | gschaider | OpenFOAM Installation | 225 | August 25, 2015 19:43 |
| "parabolicVelocity" in OpenFoam 2.1.0 ? | sawyer86 | OpenFOAM Running, Solving & CFD | 21 | February 7, 2012 11:44 |
Linear Mode
