|
[Sponsors] |
[DesignModeler] Having difficulties in creating a simple Shell Heat Exchanger |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 30, 2016, 10:07 |
Having difficulties in creating a simple Shell Heat Exchanger
|
#1 |
New Member
Jefry
Join Date: Apr 2016
Posts: 2
Rep Power: 0 |
Hi All,
I have question regarding shell heat exchange, it should be easy but I found it difficult since I was new with Fluent. How can I create the geometry to determine inlet and outlet as attached picture? I have tried like this : 1. I create circle and extrude as fluid body. 2. I create new plane and create two small circles, extrude those circles as thin/surface and imprint. Are those steps correct? Your help is greatly appreciated. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Double pipe heat exchanger | mohcin | FLUENT | 21 | June 18, 2016 14:19 |
Shell and tube heat exchanger modeling | hmasenger | CFX | 3 | January 20, 2014 03:36 |
Simple heat exchanger | strahinjailin | STAR-CCM+ | 1 | May 2, 2010 13:32 |
How to simulate 3D shell and Tube heat Exchanger | san | FLUENT | 2 | February 22, 2006 05:44 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 15:55 |