|
[Sponsors] |
[ANSYS Meshing] can I subtract pieces from mesh |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 18, 2016, 08:39 |
can I subtract pieces from mesh
|
#1 |
Senior Member
Join Date: May 2012
Location: Melbourne
Posts: 161
Rep Power: 13 |
Hi, can I cut slots from a sweeped mesh?
this picture is before |
|
May 18, 2016, 08:40 |
|
#2 |
Senior Member
Join Date: May 2012
Location: Melbourne
Posts: 161
Rep Power: 13 |
and this how it should be
so instead of joining bits in ICEM, make the sweep first and then remove parts of the mesh |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
[snappyHexMesh] Multi Region Mesh of a car filter | Zephiro88 | OpenFOAM Meshing & Mesh Conversion | 3 | September 11, 2019 19:34 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |