[DesignModeler] Problem with parameters in DM

germinal · August 31, 2016, 08:49

Hi!

I am having a problem with the parameters in DM. This should be the a very trivial thing but it doesn't work (please see pictures)

OK! when I set the diameter to 50 mm it works very nice but when I set the diameter to 20 mm DM has problems to build the geometry.

I've tried almost everything - changing the parameters order, changing the references...Probably I'm doing a mistake somewhere...has anyone a hint?

(V17.1)

Thank you :-)

Kapi · August 31, 2016, 22:23

have u clicked on it to see what error it is giving?

germinal · September 1, 2016, 03:27

Sure, sorry :-)

Kapi · September 4, 2016, 22:33

two things:
either you have assigned dimention twice or more
or the value you are giving (20) is too small for the dimension to make a close loop,hence not valid

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
area does not match neighbour by ... % -- possible face ordering problem	St.Pacholak	OpenFOAM	10	February 7, 2024 21:50
Pro/E to ANSYS Parameterization Guide	Trues	ANSYS	4	April 18, 2018 05:52
Parameters for multigrid solver	HaZe	OpenFOAM Running, Solving & CFD	3	January 28, 2012 02:05
Problem in implementing cht	tilek	CFX	3	May 8, 2011 08:39
Adiabatic and Rotating wall (Convection problem)	ParodDav	CFX	5	April 29, 2007 19:13

August 31, 2016, 22:23		#2
Kapi Senior Member Join Date: Apr 2014 Location: Melbourne Posts: 584 Rep Power: 14	have u clicked on it to see what error it is giving?

September 4, 2016, 22:33		#4
Kapi Senior Member Join Date: Apr 2014 Location: Melbourne Posts: 584 Rep Power: 14	two things: either you have assigned dimention twice or more or the value you are giving (20) is too small for the dimension to make a close loop,hence not valid