|
[Sponsors] |
November 6, 2016, 23:26 |
A blade with v-cut
|
#1 |
Senior Member
Have a nice time!
Join Date: Feb 2016
Location: mech.eng.ahmedmansour@gmail.com
Posts: 291
Rep Power: 11 |
Hello, I have a blade of a pump with a v cut and after defining the hub, shroud, inlet and outlet in blademodeler and exporting the points to the turbogrid, the blade was transferred without the v-cut...How can I define the v-cut in TurboGrid?
Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] refineWallLayer Error | Yuby | OpenFOAM Meshing & Mesh Conversion | 2 | November 11, 2021 11:04 |
[TurboGrid] Slotted rotor Blade using Turbogrid | drcsm | ANSYS Meshing & Geometry | 0 | March 15, 2016 00:26 |
Problem in conducting CFD of analysis of wind turbine blade | atulpat | CFX | 16 | August 17, 2013 04:09 |
Compressor Blade Analysis in Ansys CFX | LynchMobster47 | Main CFD Forum | 0 | April 10, 2012 22:43 |
Plotting Residuals | ata | OpenFOAM | 12 | July 8, 2011 02:50 |