|
[Sponsors] |
[ICEM] How to draw a 2D surface to a solid 3D Body |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 8, 2016, 06:13 |
How to draw a 2D surface to a solid 3D Body
|
#1 |
New Member
Bowen Li
Join Date: Nov 2016
Posts: 4
Rep Power: 9 |
Hi everbody,
I'm a beginner at ICEM. I want to know how to draw a surface to a solid body. I want to draw the surface (red part in the first Picture) to a solid body. First I copied the surface in z direction and sweeped all the curves through two points. The result please have a look at second picture. But I found that, it generate only surfaces not a closed solid body. And when I prepare to make a mesh with "curve mesh" on the entities, it occurs problem. Can any body help me to solve this prblem? I am thankful for any hint. If there's any uncertainties, please ask. Thank you! Greetings |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 11:05 |
Cluster ID's not contiguous in compute-nodes domain. ??? | Shogan | FLUENT | 1 | May 28, 2014 15:03 |
[DesignModeler] Question about converting surface body to solid body in DesignModeler | lnk | ANSYS Meshing & Geometry | 2 | November 24, 2013 00:02 |
[snappyHexMesh] Layers don't fully surround surface | EVBUCF | OpenFOAM Meshing & Mesh Conversion | 14 | August 20, 2012 04:31 |