|
[Sponsors] |
[GAMBIT] meshing for a rotating elliptic cylinder |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 27, 2020, 10:06 |
meshing for a rotating elliptic cylinder
|
#1 |
New Member
Tamil Nadu
Join Date: Nov 2020
Posts: 3
Rep Power: 5 |
hello,
I am using GAMBIT to mesh for a rotating elliptic cylinder and FLUENT for simulation . how to mesh ? is creation of overset mesh necessary to rotate the ellipse?? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Depositing fluid on rotating cylinder | kgschuch | FLUENT | 1 | October 6, 2020 13:31 |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
[ANSYS Meshing] Meshing a Cylinder | anuprdk | ANSYS Meshing & Geometry | 3 | December 9, 2014 12:32 |
Mesh type in rotating blade inside cylinder | Mah.tavana | Mesh Generation & Pre-Processing | 0 | July 26, 2014 06:53 |
[ICEM] Block meshing strategy for a radiused cylinder | Polarbear | ANSYS Meshing & Geometry | 2 | June 18, 2014 14:24 |