|
[Sponsors] |
March 4, 2017, 00:33 |
Obsolete mesh
|
#1 |
New Member
Malik
Join Date: Feb 2017
Posts: 7
Rep Power: 9 |
I am trying to mesh shell and coil geometry. But mesh fails and gives following errors .
A mesh could not be generated using the current meshing options and settings. Hint: The problem geometry areas might have been highlighted. Switching to wireframe mode may make them more visible. Use other element size or virtual topology. I attach a fig. showing problem. ways to resolve it |
|
March 5, 2017, 16:53 |
|
#2 |
Senior Member
Join Date: Apr 2014
Location: Melbourne
Posts: 584
Rep Power: 14 |
right click mesh and see problematic areas in wireframe mode
check sizing |
|
March 30, 2017, 04:31 |
Incomplete Boundary conditions
|
#3 |
New Member
Malik
Join Date: Feb 2017
Posts: 7
Rep Power: 9 |
wall-coil is not showing. Where is problem ??. With out Wall-coil there is divergence error ,temp and also that interface zone is overlapping.Pic is attached kindly review
|
|
March 30, 2017, 04:39 |
|
#4 |
Senior Member
Sebastian Engel
Join Date: Jun 2011
Location: Germany
Posts: 566
Rep Power: 20 |
What is the region "interior-coil"? Might this be your wall?
|
|
March 30, 2017, 04:46 |
Interior Coil is inside coil
|
#5 |
New Member
Malik
Join Date: Feb 2017
Posts: 7
Rep Power: 9 |
Actually i am following step by step following tutorial
https://www.youtube.com/watch?v=OnTraIGowx4 Interior coil and interior shell are two regions, But there should be Wall-shell and Wall_Coil as well. I am not familiar Interior coil and interior shell refers to what. |
|
March 30, 2017, 04:48 |
|
#6 |
New Member
Malik
Join Date: Feb 2017
Posts: 7
Rep Power: 9 |
Interior coil and interior shell are two regions, But there should be Wall-shell and Wall_Coil as well. I am not familiar Interior coil and interior shell refers to what.
But i am following below link tutorial https://www.youtube.com/watch?v=OnTraIGowx4 |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |