 |
 |
 |
|
|
|
[Sponsors] | ||||
April 3, 2017, 10:24
|
3D mesh with 'edge bias'
|
#1 |
|
New Member
Join Date: Mar 2017
Posts: 2
Rep Power: 0  |
I'm trying to make a mesh with a bias to the walls of a 3D model. The model is of a bifurcating artery.
I managed to give the inlet and two outlets an edge bias and sweep this from one end to the other. This is visible in the outlet_1 image. The outlet has the type of mesh I want (preferably even smaller though). I can't find a way to do such a thing for the lumen (not sweepable). The mesh_parameters image is the different mesh controls I'm using for the rest of the model. How would I go about making the same type of mesh for the lumen? |
|
|
|
|
 |
| Tags |
| ansys 17.2, artery, meshing 3d |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| [ANSYS Meshing] Airfoil edge sizing mesh generation problem | Kostas_K | ANSYS Meshing & Geometry | 0 | March 6, 2017 13:50 |
| [ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
| Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
Linear Mode
