 |
 |
 |
|
|
|
[Sponsors] | ||||
|
|
April 12, 2017, 03:08
|
Overlaped mesh with ATM
|
#1 |
|
New Member
jongbeom seo
Join Date: Jul 2015
Posts: 4
Rep Power: 10  |
Dear all
I imported geometry to blademodeler and exported it for Turbogrid When I use ATM optimized option for topology, mesh, you can see from the attached file, is overlaped because of curves which has large angle Question is Can I move the purple line(I think it is line of block) with ATM optimized? or Should I use control points option? And changing geometry is not available. I hope to see your kind anwser. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| [ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Hybrid Mode
