 |
 |
 |
|
|
|
[Sponsors] | ||||
June 5, 2017, 20:38
|
How to create adapated mesh in ICEM
|
#1 |
|
Senior Member
raunak jung pandey
Join Date: Jun 2016
Posts: 102
Rep Power: 9  |
I am looking to create following kind of mesh to maintain wall-normal and wall-prallel spacing near the wall.
How to create following kind of mesh 
|
|
|
|
|
|
June 6, 2017, 07:01
|
|
#2 |
|
New Member
D. N. Venturi
Join Date: Jan 2013
Location: Brazil
Posts: 25
Rep Power: 13 |
To the best of my knowledge, it is not possible to create this kind of mesh with ansys tools. Neither ICEM nor Ansys Meshing.
|
|
|
|
|
|
|
June 6, 2017, 07:38
|
|
#3 |
|
Member
Jan Surwiło
Join Date: Feb 2017
Posts: 31
Rep Power: 9 |
I'm not sure but as I remember Fluent was able to adapt mesh in that way during the calculation. Maybe Fluent Mesher is able to compute boundary layer like these.
|
|
|
|
|
|
|
June 6, 2017, 07:44
|
|
#4 |
|
Member
Join Date: Nov 2015
Posts: 30
Rep Power: 10 |
See if this helps. It's called a hanging point mesh adaptation.
http://www.afs.enea.it/project/neptu...ug/node869.htm |
|
|
|
|
|
 |
| Tags |
| icem, meshing |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| decomposePar problem: Cell 0contains face labels out of range | vaina74 | OpenFOAM Pre-Processing | 37 | July 20, 2020 05:38 |
| [ICEM] The ICEM Guide for CFX Users | JuPa | ANSYS Meshing & Geometry | 11 | September 4, 2017 09:43 |
| FLUENT - ICEM / Segmentation Violation Error (Hybrid Mesh) | Joachim | ANSYS | 3 | April 24, 2016 16:52 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| [blockMesh] Include list of points | Hikachu | OpenFOAM Meshing & Mesh Conversion | 0 | June 20, 2011 09:03 |
Linear Mode
