|
[Sponsors] |
September 10, 2017, 10:04 |
how to create sub domain in ansys
|
#1 |
New Member
Join Date: Sep 2017
Posts: 2
Rep Power: 0 |
good afternoon to all, i need help to solve the below problem which is a part of my project.
i am working with ansys polyflow- blow molding. for calculating the pure mass of the material which is blown in the cavity, ansys says that i need to define a sub domain which shows just inside the cavity, not other parts of the cavity. how can i define a sub domain for a specific part of a cavity in ansys? hope to be helped, thanks all. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Sudden increase the residual of Maxwell's equations | hsezsz | CFX | 2 | October 13, 2016 06:58 |
Monte Carlo Simulation: H-Energy is not convergating & high Incident Radiation | volleyHC | CFX | 5 | April 3, 2016 05:41 |
Create domain in Hexpress by importing geometry from CATIA V5R21 | PeiSan | Fidelity CFD | 1 | June 30, 2014 04:10 |
[GAMBIT] How to plot S pipe | mariam.sara | ANSYS Meshing & Geometry | 36 | November 7, 2013 15:22 |
[DesignModeler] Problem creating fluid domain in ansys design modeller 14.0 | rsdsaurav | ANSYS Meshing & Geometry | 2 | January 13, 2013 00:32 |