[DesignModeler] Surface from Curve not smooth

lulupearl · March 5, 2018, 11:21

Hello!
I am working on a 2D simulation of an airfoil with a rotating cylinder.

Obviously, my geometry contains a lot of curves.

I am facing problems with these curves, when I generate surfaces for these curves, the resulting surface is not smooth and looks like a bunch of connected straight lines. (See attached image)

The result is the same whether a surface was generated from an edge or a sketch.

Is this normal? Or is this a problem that can be fixed?

Please help if if this can be fixed!

Far · March 5, 2018, 11:30

artefact. The level of magnifications you are looking with does not exist in reality. And every surface is not surface when zoomed at micro level.

This issue can be solved by increasing the pixels in the geometry graphics but that would unnecessary load on your computer display and it will start to freez.

In short it is normal and leave it there.

lulupearl · March 5, 2018, 11:45

Quote:

Originally Posted by Far

artefact. The level of magnifications you are looking with does not exist in reality. And every surface is not surface when zoomed at micro level.

This issue can be solved by increasing the pixels in the geometry graphics but that would unnecessary load on your computer display and it will start to freez.

In short it is normal and leave it there.

Thank you very much. I'm glad to know this is normal!

Far · March 5, 2018, 22:35

But I do recommend that when you mesh your model, do check that the mesh represent the geometry closely within the engineering accuracy level.

March 5, 2018, 11:30		#2
Far Super Moderator Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,553 Blog Entries: 6 Rep Power: 54	artefact. The level of magnifications you are looking with does not exist in reality. And every surface is not surface when zoomed at micro level. This issue can be solved by increasing the pixels in the geometry graphics but that would unnecessary load on your computer display and it will start to freez. In short it is normal and leave it there. lulupearl likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Creating smooth curve from points in ANSYS Workbench	tshv247	ANSYS	1	December 20, 2015 14:58
[Gmsh] Problem with Gmsh	nishant_hull	OpenFOAM Meshing & Mesh Conversion	23	August 5, 2015 02:09
block-structured mesh for t-junction	Robert@cfd	ANSYS Meshing & Geometry	20	November 11, 2011 04:59
[ICEM] Automatic mesh generation script surface intersection problem	stuart23	ANSYS Meshing & Geometry	0	May 13, 2011 01:10
smooth DTF surface	N.R.	CFX	0	July 25, 2007 13:45

March 5, 2018, 22:35		#4
Far Super Moderator Sijal Join Date: Mar 2009 Location: Islamabad Posts: 4,553 Blog Entries: 6 Rep Power: 54	But I do recommend that when you mesh your model, do check that the mesh represent the geometry closely within the engineering accuracy level.