[ANSYS Meshing] Body of influence substracts from part in Ansys Meshing -- CFD Online Discussion Forums

May 2, 2018, 09:00

Body of influence substracts from part in Ansys Meshing

wimblo

New Member

William Harvey

Join Date: Jan 2018

Location: Montréal, Québec

Posts: 5

Rep Power: 8

Hi,

I want to use the body of influence sizing method in Ansys meshing.

I've created two parts in DesignModeler (see DesignModeler.jpg):
-The part I want to mesh
-The part I want to use as my body of influence

Problem is, when I open my geometry in Ansys Meshing, the parts substract from each other and don't overlap anymore (see Meshing1.jpg and Meshing2.jpg).

Therefore I cannot use the body of interest sizing.

I've tried freezing and unfreezing the parts in DesignModeler with no sucess. I can't think of anything else.

Anybody knows what my problem might be? Thanks.

Attached Images

	DesignModeler.JPG (50.4 KB, 2 views)
	Meshing1.JPG (27.4 KB, 5 views)
	Meshing2.JPG (26.5 KB, 3 views)

Tags

body of interest, sizing

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Missing Body passing from DM to ANSYS Meshing	oozcan	ANSYS Meshing & Geometry	1	December 13, 2016 19:24
[ANSYS Meshing] ANSYS Meshing Problem	Saikat_FM	ANSYS Meshing & Geometry	1	September 15, 2016 02:25
How to make appear edge/line body (created in design modeler) in the meshing tool	Rockda	ANSYS Meshing & Geometry	6	June 8, 2016 23:10
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 10:49
[ANSYS Meshing] Ansys meshing with extended meshing	jsm	ANSYS Meshing & Geometry	6	January 10, 2011 12:09

All times are GMT -4. The time now is 01:42.