 |
 |
 |
|
|
|
[Sponsors] | ||||
May 24, 2018, 06:37
|
Interface ICEM
|
#1 |
|
Senior Member
Davide
Join Date: Jul 2015
Posts: 107
Rep Power: 10  |
Hi,
I would like to pair two mesh domains in icem. One domain is entirely made with ICEM while another is done with Turbogrid, so amount in ICEM the mesh in CNS format. In the surface where there is the interface between the two domains how can I make the mesh congruent? Tahnk you Davide |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] ICEM CFD Interface meshing problem | gamemakerh | ANSYS Meshing & Geometry | 1 | December 12, 2016 03:41 |
| [ICEM] missing interface between two zone while importing from ICEM to FLUENT | @nuj | ANSYS Meshing & Geometry | 0 | April 6, 2016 08:23 |
| Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
| An error has occurred in cfx5solve: | volo87 | CFX | 5 | June 14, 2013 17:44 |
| ICEM CFD 11 interface in ProE wildfire 4.0 | seaning | ANSYS | 1 | July 14, 2009 03:04 |
Linear Mode
