 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] missing interface between two zone while importing from ICEM to FLUENT |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 6, 2016, 08:23
|
missing interface between two zone while importing from ICEM to FLUENT
|
#1 |
|
New Member
Anuj
Join Date: Apr 2016
Posts: 4
Rep Power: 7  |
I am trying to create mesh in ICEM CFD. In this case, my domain has two zones i.e. water channel (outer) and rotating zone (inner) (see figure attached below). After creating mesh, mesh is transferred to FLUENT.
Two zones are shown in cell zone. But, interface between both the zones is not shown. Only one interface (interface_1) is associated which gives error in mesh checking. Interface-2 is missing which is necessary to create a interface between rotating and stationary body. Kindly suggest me how to create interface while meshing in ICEM ? Plz help I am stuck in this problem for a long time |
|
|
|
|
|
| Tags |
| fluent 14.0, icem cfd, meshing |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| sliding mesh problem in CFX | Saima | CFX | 45 | September 22, 2015 10:53 |
| fluent Note: zone-surface: cannot create surface from sliding interface zone | sachinip | FLUENT | 4 | November 12, 2014 10:00 |
| Possible Bug in pimpleFoam (or createPatch) (or fluent3DMeshToFoam) | cfdonline2mohsen | OpenFOAM | 3 | October 21, 2013 09:28 |
| [Commercial meshers] fluentMeshToFoam multidomain mesh conversion problem | Attesz | OpenFOAM Meshing & Mesh Conversion | 12 | May 2, 2013 10:52 |
1Likes
Linear Mode
