|
[Sponsors] |
July 19, 2018, 06:55 |
Meshing
|
#1 |
New Member
|
Hello everyone,
Now I'm working on a project "CFD simulation micro fluid" where I've to mesh a fluid domain which consists a rotating blade. My problem is even when all the values are default like element size etc my elements are crossed more than a 2 million. Do we have to minimise the elements in the fluid region or around the blade? Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] snappyHexMesh - 3D Wing Meshing Setup & Trials | denbjornen | OpenFOAM Meshing & Mesh Conversion | 1 | May 25, 2020 11:14 |
[ANSYS Meshing] only automatic meshing works, | kazra | ANSYS Meshing & Geometry | 2 | February 23, 2017 11:38 |
[Gmsh] 3D coil mesh: can't create the volume? | RomainBou | OpenFOAM Meshing & Mesh Conversion | 3 | July 18, 2016 05:09 |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |