|
[Sponsors] |
[DesignModeler] IC Engine Fluent geometry decompose |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 30, 2018, 08:23 |
IC Engine Fluent geometry decompose
|
#1 |
New Member
Laura
Join Date: Jul 2018
Posts: 14
Rep Power: 7 |
Hi! I’m trying to simulate a full engine cycle with the tool IC Engine (fluent) but I have problem with the decomposition in DM. It says to check the valve seat, I’ve done all as it’s written on the guide, but it doesn’t work! Do you have any advice? Thanks!IMG_9707.jpg
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Running UDF with Supercomputer | roi247 | FLUENT | 4 | October 15, 2015 13:41 |
Using FLUENT in parallel using Oracle Sun Grid Engine | peter.pan | FLUENT | 1 | November 21, 2014 09:05 |
The fluent stopped and errors with "Emergency: received SIGHUP signal" | yuyuxuan | FLUENT | 0 | December 3, 2013 22:56 |
[DesignModeler] Geometry working in GAMBIT but not FLUENT | CDollarsign | ANSYS Meshing & Geometry | 5 | September 13, 2012 09:29 |
[ICEM] Tips for 3D tetra mesh quality for Fluent transient run. Rotary Engine | Catthan | ANSYS Meshing & Geometry | 0 | June 18, 2012 12:46 |