[ANSYS Meshing] 2D meshing of a converging duct for combustor

hakan · June 9, 2021, 12:16

Greetings, I am trying to simulate a flow in a 2D micro channel. The case is from a paper. I am a beginner in CFD. In the paper there is an intense zone near the converging wall as I have shared in the picture. I am having diffuculties obtaining this mesh. I have used face meshing and sizing but the cells outside are deformed and this disturbs my solution. How can I achieve such a mesh?

Thank you for your help.

aero_head · June 14, 2021, 01:10

Hello,

You should upload/attach your photos right to your post. Here's a link that goes over how to do this: https://www.cfd-online.com/Wiki/Ansy...n_the_forum.3F

hakan · June 16, 2021, 07:29

I have edited the post. Thank you for mentioning how to add pictures.

hakan · July 11, 2021, 12:09

I am still trying to create the mesh I have mentioned. I would appreciate any help. Thanks in advance.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Meshing a very long and tiny duct	simo88	ANSYS Meshing & Geometry	6	January 21, 2021 17:24
[ICEM] 3D duct meshing problem	adnan.nweilati	ANSYS Meshing & Geometry	3	November 17, 2014 09:17
meshing a duct in gambit	ako	ANSYS Meshing & Geometry	7	April 2, 2009 22:07
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 11:09
GAMBIT meshing problem	Gauthier Lambert	Main CFD Forum	1	August 3, 2000 09:22

June 14, 2021, 01:10		#2
aero_head Senior Member Kira Join Date: Nov 2020 Location: Canada Posts: 435 Rep Power: 8	Hello, You should upload/attach your photos right to your post. Here's a link that goes over how to do this: https://www.cfd-online.com/Wiki/Ansy...n_the_forum.3F

June 16, 2021, 07:29		#3
hakan New Member Turkey Join Date: May 2021 Posts: 4 Rep Power: 4	I have edited the post. Thank you for mentioning how to add pictures.

July 11, 2021, 12:09		#4
hakan New Member Turkey Join Date: May 2021 Posts: 4 Rep Power: 4	I am still trying to create the mesh I have mentioned. I would appreciate any help. Thanks in advance.