[DesignModeler] How to design the geometry of a Subsea Jumper using Ansys.

Faro · August 1, 2019, 09:04

I am trying to recreate the attached image on Ansys, although I have been able to develop this sketches but the application of sweep keep telling me "sweep path must contain exactly one chain ansys".

How do I go about this? Your suggestions would be well appreciated.

Gweher · August 12, 2019, 08:10

Hi Faro,

According to your sketch you didn't add the horizontal lines, hence you'll end up with several "sub" lines in one sketch which cannot be used for the sweep path.

If you correct those you should be fine.

Have fun

MIDHUN@CFD · August 13, 2019, 11:27

make the bend radius little more higher and try

Gweher · August 14, 2019, 02:20

The bend radius is not the problem here as the extruded profile is not self intersecting at the different bends.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error Running Design of Experiments in ANSYS Fluent	tytrzecki	FLUENT	0	April 22, 2018 15:01
Pro/E to ANSYS Parameterization Guide	Trues	ANSYS	4	April 18, 2018 05:52
ANSYS: Design of Experiments and Optimization - Upper and Lower Bounds	mrswordf1sh	ANSYS	0	April 5, 2018 07:33
Issues Importing Geometry (Hyperloop Design)	iiwolf	ANSYS	1	December 2, 2015 18:25
2-way FSI in Ansys CFX 15	LucasGasparino	CFX	3	August 6, 2015 03:17

August 12, 2019, 08:10		#2
Gweher Senior Member Gwenael H. Join Date: Mar 2011 Location: Switzerland Posts: 392 Rep Power: 20	Hi Faro, According to your sketch you didn't add the horizontal lines, hence you'll end up with several "sub" lines in one sketch which cannot be used for the sweep path. If you correct those you should be fine. Have fun

August 13, 2019, 11:27		#3
MIDHUN@CFD Member MIDHUN Join Date: Nov 2012 Location: calicut Posts: 45 Rep Power: 13	make the bend radius little more higher and try

August 14, 2019, 02:20		#4
Gweher Senior Member Gwenael H. Join Date: Mar 2011 Location: Switzerland Posts: 392 Rep Power: 20	The bend radius is not the problem here as the extruded profile is not self intersecting at the different bends.