|
[Sponsors] |
July 22, 2019, 04:37 |
Turbogrid Meshing Manually.
|
#1 |
New Member
keisol
Join Date: Jul 2019
Posts: 1
Rep Power: 0 |
Hello Everyone.
I've tried to make a grid for blades group, one of them is deformed, others not. However, system says that I have to make a topology manually due to no appropriate topology set. But I have no idea how to setting. Does anyone know how to mesh manually? thanks. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] TurboGrid - problem with trailing edges ending with hub/shroud curve | TTM | ANSYS Meshing & Geometry | 8 | February 16, 2020 07:11 |
[TGrid] Turbogrid splitter meshing | czm28 | ANSYS Meshing & Geometry | 0 | December 4, 2014 07:48 |
Meshing software comparison | Wikie | Mesh Generation & Pre-Processing | 5 | September 29, 2014 06:09 |
[ANSYS Meshing] Meshing strategy for External Flows | Hybrid | ANSYS Meshing & Geometry | 0 | January 24, 2012 14:27 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |