|
[Sponsors] |
[ANSYS Meshing] can't modify the mesh for element size of 3e-7 |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 12, 2019, 14:10 |
can't modify the mesh for element size of 3e-7
|
#1 |
New Member
raushan kumar
Join Date: Sep 2015
Posts: 11
Rep Power: 10 |
Dear All,
I know this question has asked before but I can't get a full solution. Now, I can't modify the mesh for an element size of 3e-7 meters and less. For your reference, I am also attaching my mesh setting. During meshing at 3e-7 meters element size nothing is happening from around 30 hours. I had tried the same meshing with 16 GB and 8 core processor windows 7 operating system and 8 GB 4 core processor with windows 10 OS. Please help me to figure out this issue. Thanking you in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DPM simulation-Restrictions on the mesh size to particle size ratio? | cryabroad | Fluent Multiphase | 5 | June 16, 2022 01:51 |
[ICEM] Effect of globle mesh size and mesh independency | sujay | ANSYS Meshing & Geometry | 20 | September 29, 2019 07:36 |
[mesh manipulation] How to write cellSet for different regions in constant/polyMesh/sets | Struggle_Achieve | OpenFOAM Meshing & Mesh Conversion | 3 | June 17, 2019 09:29 |
[snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |
Phase locked average in run time | panara | OpenFOAM | 2 | February 20, 2008 14:37 |