|
[Sponsors] |
[ICEM] Unlink nodes of blocks separated by a VORFN |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 26, 2019, 23:35 |
Unlink nodes of blocks separated by a VORFN
|
#1 |
New Member
Rafael
Join Date: Sep 2019
Posts: 2
Rep Power: 0 |
Is there a way to unlink the number of nodes for a 2D hexa geometry, as seen in the figure? I want the block 25 to have less nodes than blocks 21 and 23, but i didn't find a way to deal with this.
Thanks in advance . |
|
November 27, 2019, 04:37 |
|
#2 |
Senior Member
Sebastian Engel
Join Date: Jun 2011
Location: Germany
Posts: 566
Rep Power: 20 |
delete block 24 again but activate the check box for permanent delete.
|
|
November 27, 2019, 09:24 |
|
#3 | |
New Member
Rafael
Join Date: Sep 2019
Posts: 2
Rep Power: 0 |
Quote:
Worked just fine! I actually did this one time but it messed up the VORFN blocks, and i thought this had altered the normal blocks geometry, but when i unchecked the vorfn box the pre-mesh was ok. Many thanks! |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Commercial meshers] COnvert FLuent MEsh to openfoam with interface | manuc | OpenFOAM Meshing & Mesh Conversion | 1 | July 25, 2017 03:13 |
[Commercial meshers] converting Fluent mesh to openfoam standard mesh | deepesh | OpenFOAM Meshing & Mesh Conversion | 31 | March 29, 2017 05:59 |
dsmcInitialise - dsmcFoam | archymedes | OpenFOAM Pre-Processing | 94 | July 15, 2016 16:14 |
[ICEM] Dissociate blocks number of nodes | gi12 | ANSYS Meshing & Geometry | 2 | February 23, 2012 22:33 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |