|
[Sponsors] |
February 19, 2020, 03:01 |
to selected edges in icem
|
#1 |
New Member
saeedeh.hamoudi
Join Date: Feb 2020
Posts: 2
Rep Power: 0 |
. Someone has a solution to this problem.
Thank you Last edited by saeedeh_hamoudi; February 19, 2020 at 03:25. Reason: I work on a structured mesh and nodes each edges individually, although the copy option is inactive, but nods again to parall |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SHM Layer Addition Phase | dickcruz | OpenFOAM Meshing & Mesh Conversion | 4 | November 1, 2018 07:05 |
[surface handling] surfaceFeatureExtract fails to generate .eMesh file from .stl file | buckleup | OpenFOAM Meshing & Mesh Conversion | 1 | August 24, 2018 09:44 |
Aligned edges in ICEM | RichardG | ANSYS Meshing & Geometry | 28 | March 14, 2017 11:40 |
[snappyHexMesh] problems using snappyHexMesh 2.1.0 on a supercomputer | Sunxing | OpenFOAM Meshing & Mesh Conversion | 9 | September 20, 2014 09:30 |
Delete block edges in ICEM CFD | YK | CFX | 1 | June 22, 2008 14:30 |