|
[Sponsors] |
May 27, 2020, 02:54 |
Help with Inflation
|
#1 |
New Member
M.Eid
Join Date: Apr 2018
Posts: 27
Rep Power: 8 |
Hello all,
I am trying to generate an inflation layer on this blade but despite using Total Thickness option, the thicknessnat the tip is bigger and the inflation is distoreted. I think the problem is caused by the curvature at the tip. Also i noticed the problem gets worse when I increase the total thickness of the inflation Any ideas? Thanks in advance mesh7.jpg IMG_1480.jpg IMG_1482.jpg |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boundary Layer - Inflation Layer | dlkadk | FLUENT | 0 | September 16, 2017 11:11 |
[ANSYS Meshing] 3D Inflation mesh on an airfoil | kennyboy | ANSYS Meshing & Geometry | 1 | April 26, 2017 03:12 |
[ANSYS Meshing] Inflation Layers Being Finicky | Markua | ANSYS Meshing & Geometry | 12 | April 28, 2015 07:11 |
Fluent diverges when using inflation layers | ziggo | FLUENT | 4 | August 9, 2013 12:11 |
Large Valve Flow Analysis - Inflation Problem | sercan85 | ANSYS Meshing & Geometry | 2 | June 1, 2010 14:02 |