|
[Sponsors] |
February 12, 2021, 10:57 |
[ICEM] How to use Split Wall command?
|
#1 |
Member
MWRS
Join Date: Apr 2018
Location: Islamabad
Posts: 99
Rep Power: 8 |
Hi all. I have a question about the split wall option. If applied to a single surface, it has overlapping set of elements on each side of it. I have observed the following two features:-
1) Check mesh shows surface orientation and overlapping element error. 2) Fluent says "there is only one adjacent cell thread" and declares it as wall. 3) Fluent would make it interior but the behavior of the surface would be as wall and barrier to flow field. I want to make it interior volume surface. How do I do that? Thank you |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two phase flow in porous medium | Milaad | OpenFOAM | 6 | December 15, 2020 07:55 |
What's the problem with turbulence models near the wall region? | Jaydi_21 | Main CFD Forum | 6 | July 7, 2017 02:39 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Wall functions | Abhijit Tilak | Main CFD Forum | 6 | February 5, 1999 01:16 |