Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[DesignModeler] Different Results when I use the "Imprint Faces" tool

Updated Threads

Search this Thread

Prev

Previous Post

Next Post

Next

May 13, 2021, 13:25	Different Results when I use the "Imprint Faces" tool	#1
Aspa New Member Aspa Join Date: May 2021 Posts: 2 Rep Power: 0	Hello, I've been trying to model a turbofan's intercompressor duct in CFX in which I also added 2 horizontal extensions before and after it. I tried two different ways, (1)by designing, meshing and modelling the whole duct altogether and (2) by separating the "real" duct using the "Imprint Faces" tool in DesignModeler. Even though I use the same meshing options and boundary conditions in the two cases I get different results (pressure losses). Is there a way the results could be affected by this design change?

Tags

cfx & fluent, design modeller, imprint face

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
bad heat transfer results with low y+	me45	OpenFOAM Running, Solving & CFD	0	April 29, 2020 11:56
Plot Contact Tool Results Using Path for multiple load steps	mirghani	Structural Mechanics	0	April 1, 2020 06:19
tool for time averaging results	gittagawa	SU2	4	December 4, 2019 08:54
Error Interpolating Results onto New Mesh	nammeh	CFX	1	March 26, 2019 12:08
Creating a tool to interpolate results	Luis Batista	OpenFOAM Running, Solving & CFD	2	April 11, 2013 08:15

All times are GMT -4. The time now is 04:09.