|
[Sponsors] |
September 3, 2021, 04:44 |
Preference in tree
|
#1 |
Member
Adithya
Join Date: May 2021
Posts: 73
Rep Power: 4 |
Hi, I am ANSYS Meshing for preparing meshes for Fluent.
Is there an order of preference to the sizings we insert in the tree? For example, if I have a fine refinement on some faces and then lower in the tree i select a few of those faces for further refinement, will those select faces be refined? Same question about coarseness. I am working with many body of influences. At the moment, i have bodies with increasing refinement in my tree as you go down the tree. But, i need to add another body that will surround the above bodies . this new body will be coarser. I don't want my previous elements to become coarse |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CCM+ Simulation Assistant - Selection in Object Tree | lee_2017 | STAR-CCM+ | 1 | December 18, 2018 08:56 |
Flow temperature simulation around a single tree | just_me | System Analysis | 0 | December 16, 2016 07:17 |
[GAMBIT] Need help in modeling and meshing air flow over a tree | czi1127 | ANSYS Meshing & Geometry | 1 | December 19, 2012 03:43 |
Internal Error: Number of tree levels exceeded | ahlo | CFX | 0 | March 4, 2008 13:45 |
Number of tree levels exceeded | ahlo | CFX | 0 | August 29, 2007 10:26 |