 |
 |
 |
|
|
|
[Sponsors] | ||||
[ICEM] Meshing parameter not showing correct value |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 21, 2022, 08:55
|
Meshing parameter not showing correct value
|
#1 |
|
New Member
Md. Mesbahose Salekeen
Join Date: May 2018
Posts: 12
Rep Power: 7  |
I am trying to mesh Airfoil NACA-66(3)-018 with ICEM CFD ANSYS R2 2020
How do i fix this? |
|
|
|
|
|
May 27, 2022, 03:17
|
|
#2 |
|
Senior Member
Alain Islas
Join Date: Nov 2019
Location: Mexico
Posts: 142
Rep Power: 6 |
When defining the number of nodes on either edge, please be sure to check box "copy to parallel edges"
|
|
|
|
|
|
|
May 31, 2022, 02:15
|
|
#3 |
|
Member
Chrowale
Join Date: Sep 2021
Location: Bandung, Indonesia
Posts: 59
Rep Power: 4 |
This has to do with the differing mesh law in each edge. Usually if generated using ICEM global setting, sometimes it has a mind of its own
 . I prefer to do it manually by parallel selections.Regards Lucky |
|
|
|
|
|
|
| Tags |
| icem 2d blocking, mesh 2d |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Gmsh] gmshToFoam generates patches with 0 faces and 0 points | Simurgh | OpenFOAM Meshing & Mesh Conversion | 4 | August 25, 2023 07:58 |
| [ANSYS Meshing] Help about meshing well | berkmm | ANSYS Meshing & Geometry | 1 | May 11, 2020 15:32 |
| meshing small gaps: what parameter do I have to keep that holes clear? | pablo_fil | STAR-CCM+ | 1 | November 16, 2014 06:02 |
| Meshing software comparison | Wikie | Mesh Generation & Pre-Processing | 5 | September 29, 2014 06:09 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |
Linear Mode
