|
[Sponsors] |
[ANSYS Meshing] Inflation layers around corner + 180° |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
December 16, 2022, 04:35 |
Inflation layers around corner + 180°
|
#1 |
New Member
Join Date: Dec 2022
Posts: 2
Rep Power: 0 |
Hey folks,
is there a possible way to to have the inflation-layers go around the corner instead of the shrinking down towards the edge (see picture). Thanks for your help. Bildschirmfoto 2022-12-16 um 08.35.08.png Last edited by Roybaer; December 16, 2022 at 08:59. |
|
December 17, 2022, 06:03 |
|
#2 |
Senior Member
Stuart
Join Date: Jul 2009
Location: Portsmouth, England
Posts: 739
Rep Power: 26 |
Your image appears to show a straight horizontal line at the corner, is your gometry 2 separate bodies? If so then it is not possible.
|
|
December 17, 2022, 07:02 |
Thanks
|
#3 |
New Member
Join Date: Dec 2022
Posts: 2
Rep Power: 0 |
||
Tags |
cfx, inflation layers, meshing advice |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ANSYS Fluent Meshing: Incomplete Inflation Layers | sbro | FLUENT | 1 | October 26, 2020 15:04 |
[ANSYS Meshing] Inflation layers element quality | frossi | ANSYS Meshing & Geometry | 0 | July 2, 2016 20:19 |
[ANSYS Meshing] Inflation Layers Being Finicky | Markua | ANSYS Meshing & Geometry | 12 | April 28, 2015 07:11 |
[ANSYS Meshing] Inflation Layers disappearing - airfoil | krekel13 | ANSYS Meshing & Geometry | 0 | January 24, 2015 13:55 |
Fluent diverges when using inflation layers | ziggo | FLUENT | 4 | August 9, 2013 12:11 |